Welcome to the Fleshlight Forums.

Search:

Type: Posts; User: Lurker

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Re: Can you use microfiber-cloth to clean/dry out the water from the inside?

    Microfiber cloth can still leave lint (that's inherent with woven fibers), but I've been using it for years and I haven't noticed any accumulating on any of my sleeves. Leave it like this overnight...
  2. Replies
    10
    Views
    986

    Re: one small complaint.

    I wonder if they don't care or if they don't know. In any case, from now on my orders will be off the books using gift "credit cards".

    edit: Man, these forums need a lot of work.
  3. Replies
    6
    Views
    508

    Re: Weird forum layout

    https://forums.fleshlight.com/showthread.php?31838-Forum-reads-bottom-to-top
  4. Replies
    5
    Views
    1,786

    Re: Flight or Destroya

    You're talking about just inside the entrance of the sleeve, right? I have those on a lot of my sleeves too. They are generated by the seam between the orifice mold and the texture rod during...
  5. Re: Which sleeve requires the least amount of lube?

    Out of all of the sleeve that I own, the Pure seems to require the least work to keep lubed, but if you aren't using enough lube in the first place, you're going to have a bad time. And using...
  6. Replies
    4
    Views
    469

    Re: Forum reads bottom to top

    Click "Settings" in the top right of the forum page. Find "General Settings" in the lower left. Under "Thread Display Options", pick "Linear - Oldest First" from "Thread Display Mode", then "Save...
  7. Replies
    5
    Views
    856

    Re: Squeeky inner surface

    The primary ingredients of Albolene appear to be mineral oil and petroleum. I suspect that might be at least part of your problem.
  8. Replies
    8
    Views
    3,936

    Re: Racist porn stars? Who knew?

    In a profession like adult films, I think that someone is well within there right to turn down a role with an individual that they are not comfortable with. If they straight out state that they...
  9. Replies
    17
    Views
    3,064

    Re: Warming question

    I should add that heating a sleeve above ~35C (95F) is uncomfortably warm. I would go so far as to say that 33C still feels warmer than any vagina that I can recall, but it has been quite a while.
  10. Replies
    17
    Views
    3,064

    Re: Warming question

    I wrap a complete FL (case, caps, sleeve) in the pad with its fabric cover. The key is to use the low setting over a long duration. The high setting can easily make your FL hot enough to deform.
  11. Replies
    17
    Views
    3,064

    Re: Warming question

    If you don't mind using hot water, using an insulated jug will trap the heat really well. Keep in mind that as the sleeve absorbs the heat, the water will cool so you might give it a half hour and...
  12. Replies
    17
    Views
    3,064

    Re: Warming question

    I beg to differ. The fact is that FL's are decent insulators and do not absorb heat quickly. That is why warming them slowly with low heat is the safest way. After ~2 hours in an electric pad on...
  13. Replies
    2
    Views
    568

    Re: A Shedding Sleeve

    That sounds really weird. I would like to see a picture. Hold it near a lamp so that you have enough light for a clear picture.
  14. Replies
    17
    Views
    3,064

    Re: Warming question

    I don't know the maximum safe temperature that you can apply to warm a FL without damaging it, but I used to warm mine in ~55C water without any problems. I use an electric heat therapy pad now, but...
  15. Replies
    16
    Views
    1,828

    Re: Need some advice

    Seriously. I wish it was just that simple.
  16. Replies
    5
    Views
    2,042

    Re: any substitute for Fleshlight lubricant

    If you find a store that sells condoms, you can almost be sure that they will sell lubricants that you can use with your FL. As Horse said, ask for water-based only. Oil and silicone based lubes...
  17. Replies
    16
    Views
    1,828

    Re: Need some advice

    From what I understand, you have to stop "cold turkey" for about 2 months to let your brain reset.
  18. Replies
    16
    Views
    1,828

    Re: Need some advice

    It may not be testosterone levels specifically, but the topic of "porn-inducted erectile dysfunction" has been broached a few times on these boards. The basic premise is that younger men (~20) begin...
  19. Replies
    10
    Views
    1,503

    Re: Uh, what just happened?

    In the very bottom, right-hand corner of forum pages, above the Fleshlight logo, there is a BBS style drop-down menu. Options with the "Fluid" suffix will make the pages fill your screen...
  20. Replies
    4
    Views
    986

    Re: What would you do in my situation?

    Agree to her terms, take a shopping trip together to a toy shop, pick out the smallest vibe/dong you can find and enjoy gaming her game. It's not too much of her to ask you to give a little for her...
  21. Replies
    16
    Views
    2,668

    Re: Help! Mould on my fleshlight!

    Pro-tip: If you want your sleeves to stay clean looking, treat them like a piece of meat. Never handle them with unwashed hands and never let them come in contact with a surface that you wouldn't...
  22. Replies
    13
    Views
    2,501

    Re: Question for you circumcised guys.

    Thanks for bringing the "Manhood" to my attention. A few years back, I discovered how much I hate being cut and kept thinking about foreskin restoration, but I wasn't sure that I wanted to subject...
  23. Replies
    10
    Views
    3,660

    Re: The Girl(s) versus the Texture

    And it is infinitely superior to the original "Closet/Stealth" orifice. Now it needs more texture options. ;)
  24. Replies
    6
    Views
    2,021

    Re: Cleaning and maintaining your Fleshlight

    Anything other than isopropyl alcohol is not officially sanctioned by ILF. "Rubbing alcohols" can have oils and other extracts in them so I would never use them on my sleeves. It sounds like what...
  25. Re: Shipping to Canada is now beyond the point of absurdity

    It is really unfortunate that this is still an issue. I am sure that ILF wants Canadian customers too, but for whatever reason they can't get the shipping and handling figured out. I wouldn't be...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Back to top